Pick-And-Hold PWM Modules Are Reliable, Cost Effective

Pick-And-Hold PWM Modules Are Reliable, Cost Effective

Presented as a very low-cost solution for solenoid control electronics, the company’s 3” x 3” x 0.85” PH-ET Pick & Hold" module is said to be easy to integrate into both new and existing applications. The module is based on a micro-controller that can be reprogrammed for specific applications. It operates on a single supply voltage from +9 to +50 Vdc with a holding current of 4A with a peak or "Pick" current of 15A. Higher current and voltages are also available. A datasheet is available at http://www.oesincorp.com/pdf/pick-and-hold-module-data-sheet.pdf

 

OES

Van Nuys, CA

888-777-1826

818-222-9200

[email protected]

http://www.oesincorp.com

Suggested Articles

Low-level autonomy vehicles will grow by 11% a year and there won’t be any produced at the highest autonomy before 2024, according to IDC.

Analyst firm sees yearly growth in use of 5G wireless used in comms and guidance for vehicles despite pandemic slowdown

Nvidia plans to use new Arm Cortex CPU design in its next-gen Orin SoC